EasyManuals Logo
Home>KYMCO>Motorcycle>CV3 Series

KYMCO CV3 Series User Manual

KYMCO CV3 Series
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
3
Control Functions of Mechanism
33
4
When Welcome Light is set to enabled:
a. The Welcome Light is only activated on a
subsequent connection of a Bluetooth Device.
Each activation lasts for 2 minutes before
switching off automatically.
b. After each ride, a single cell phone linkage will
only activate the Welcome Light 3 times; the
Welcome Light will shut off Bluetooth functions
automatically after being activated 3 times.
c. Entering the Find My Scooter screen will cover
functions a and b, in which case the system
enables the Welcome Light until the user gets out
of Bluetooth range or disables the Bluetooth
connection function.
d. After the “Welcome” indicator extinguishes, it will
maintain standby status for 13 days (allowing
you to execute the setting in the APP). If the
standby duration expires or if the battery voltage
is too low (about 12V), the Bluetooth function will
shut down automatically.
12. When the KEYLESS Main Switch is OFF, all the
information will be removed, to prevent the leaking of
personal info.
13. App info display speed may be limited due to network
transfer rate, therefore resulting in slow data
indication under poor networking speeds.
14. There are certain app notice limitations between iOS
and Android systems.
15. There is a possibility that app functions may become
unusable after upgrading iOS and Android software;
some new cell phone models may have unusability
issues.
16. When using the noodoe function, make sure that the
batteries of both the cell phone and scooter are fully
charged. If you need to start the engine for charging,
do it in a well ventilated place.
17. The noodoe system will be switched off automatically
if battery power is low (about 12V) for 30s; if battery
voltage is lower than 11.8V, please start the engine
or stop using the system and go to a KYMCO dealer
for checking the circuitry.
18. The noodoe system may shut off and enter into
protection mode due to excessive temperature rise
under certain special environment or mode; however
the system will resume operation when the
temperature drops.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KYMCO CV3 Series and is the answer not in the manual?

KYMCO CV3 Series Specifications

General IconGeneral
BrandKYMCO
ModelCV3 Series
CategoryMotorcycle
LanguageEnglish

Related product manuals