KYMCO K-XCT 125i User Manual

1. GENERAL INFORMATION
1-4
K-XCT 125i
 After operation, terminal caps shall be
installed securely.
 When taking out the connector, the lock on
the connector shall be released before
operation.
 Hold the connector body when connecting
or disconnecting it.
 Do not pull the connector wire.
 Check if any connector terminal is bending,
protruding or loose.
 The connector shall be inserted
completely.
 If the double connector has a lock, lock
it at the correct position.
 Check if there is any loose wire.
 Before connecting a terminal, check for
damaged terminal cover or loose negative
terminal.
 Check the double connector cover for
proper coverage and installation.
 Insert the terminal completely.
 Check the terminal cover for proper
coverage.
 Do not make the terminal cover opening
face up.
 Secure wire harnesses to the frame with
their respective wire bands at the
designated locations.
Tighten the bands so that only the
insulated surfaces contact the wire
harnesses.
 After clamping, check each wire to make
sure it is secure.
Confirm
Capacity

KYMCO K-XCT 125i Specifications

General

Brand	KYMCO
Model	K-XCT 125i
Category	Motorcycle
Language	English

Summary

1. GENERAL INFORMATION

SERVICE PRECAUTIONS

Important safety and operational guidelines for servicing the motorcycle, covering general practices and warnings.

3. INSPECTION/ADJUSTMENT

ENGINE OIL

Information on engine oil selection, capacity, and procedures for checking and replacing the oil.

5. ENGINE REMOVAL/INSTALLATION

ENGINE REMOVAL/INSTALLATION

Comprehensive steps for safely removing and installing the engine from the motorcycle.

12. COOLING SYSTEM

COOLANT REPLACEMENT

Procedures for draining, flushing, and refilling the cooling system with the correct coolant mixture.

14. K-XCT 125 i FUEL SYSTEM (Auto Control Fuel Injection System)

CHECK ENGINE LAMP (CELP)

Explanation of the check engine lamp indicators, fault codes, and priority grades.

CELP FAILURE CODES CHART

15. HANDLEBAR/FRONT WHEEL/FRONT BRAKE/ FRONT SHOCK ABSORBER/STEERING STEM

Steering Stem Removal

Front Fork Removal and Installation

17. BATTERY/CHARGING SYSTEM

BATTERY

CHARGING VOLTAGE INSPECTION

18. IGNITION SYSTEM

IGNITION COIL INSPECTION