KYMCO K-XCT 125i User Manual

1. GENERAL INFORMATION
1-3
K-XCT 125i
SERVICE PRECAUTIONS
 Make sure to install new gaskets, O-rings,
circlips, cotter pins, etc. when
reassembling.
 When tightening bolts or nuts, begin with
larger-diameter to smaller ones at several
times, and tighten to the specified torque
diagonally.
 Use genuine parts and lubricants.
 When servicing the motorcycle, be sure to
use special tools for removal and
installation.
 After disassembly, clean removed parts.
Lubricate sliding surfaces with engine oil
before reassembly.
 Apply or add designated greases and
lubricants to the specified lubrication
points.
 When two persons work together, pay
attention to the mutual working safety.
 Disconnect the battery negative (-) terminal
before operation.
 When using a spanner or other tools,
make sure not to damage the motorcycle
surface.
 After operation, check all connecting points,
fasteners, and lines for proper connection
and installation.
 When connecting the battery, the positive
(+) terminal must be connected first.
 After connection, apply grease to the
battery terminals.
 Terminal caps shall be installed securely.
 If the fuse is burned out, find the cause
and repair it. Replace it with a new one
according to the specified capacity.

KYMCO K-XCT 125i Specifications

General

Brand	KYMCO
Model	K-XCT 125i
Category	Motorcycle
Language	English