MAINTENANCE
Transmission Gear Oil change
1. Stand the scooter by the center stand.
2. Remove the gear oil drain bolt ①.
3. Remove the gear oil filler bolt ②, and then slowly
rotate the rear wheel to drain the gear oil off.
4. Fill with the recommended oil to reach the capacity
listed below.
5. Install the transmission filler bolt and tighten it to
the specified torque.
Gear oil type: SAE 90#
LIKE 150i
Full capacity: 0
.14 L
(0.15 US QT)
Exchange capacity: 0.
12L
(0.13 US QT)
LIKE 50i
Full capacity: 0
.12 L
(0.13 US QT)
Exchange capacity: 0.
11L
(0.12 US QT)
CAUTION
Use the genuine engine oil or another with the
same quality and grade to avoid burnout on
the bearing or damage on the gear set.
CAUTION
Must follow the local regulation and obey the
related prohibition about the disposal of oil.
To Next Page
Loading...
Need help?
General
