Pushing
37
Disengaging the drive
9.0
Pushing
In order to be able to push the scooter you
must disengage the drive motor.
The disengaging lever (1) is located on the
rear right-hand side of the scooter.
No one is permitted to sit on the scooter
when it is being pushed.
= Pushing (a):
Switch the ForU off.
Push the disengaging lever (1) forwards
as far as the stop (limit position).
=Dr
iving (b):
Pull the disengaging lever (1) to the rear
as far as the stop (limit position).
NOTES
• Always switch
off to push.
• If a pre-set speed is exceeded while you are pushing,
the drive motor will switch on automatically and brake the scooter.
Risk of accidents!
•
Do
not
pull
the
disengaging
lever while driving.
•
Never
switch to push mode when somebody is
sitting
on
the scooter.
• The
engaging
lever
always
needs to engage securely at the
limit position.
•
Do
not
disengage
the motor when on an incline.
10
.
0
Attaching the s
hopping b
asket
Push the shopping basket (1) from
a
bove into the basket holder receptacles
(2) on the tiller.
NOTE
Use the shopping basket only for
small loading
To Next Page
Loading...
Need help?
General