Make sure there is no brake fluid leakage.
Check operation of the levers and pedal. They
should move smoothly and there should be a
firm feeling when the brake is applied. If not,
have the machine inspected by a KYMCO
dealer.
Brake operation
Test the brakes at slow speed after starting
out to make sure they are working properly. If
the brakes do not provide proper braking
performance, inspect the brakes for wear.
(See page 152~159.)
FRONT AND REAR BRAKES
1.
2.
3.
(1) Locknuts (6) Drive select lever
(2) Rod (N) Neutral
(3) Standard/phillips screwdriver
(1)
(2)
(3)
(N)
(6)
56
Turn the rod (2) clockwise or
counterclockwise until the drive select lever
(6) into the "N" position of the shift guide and
tighten the locknuts, then pull out the
standard/phillips screwdriver.
After adjustment, start the engine and test
ride the ATV to be sure the drive select lever is
operating properly. (See page 71~73.)
5.
6.
To Next Page
Loading...
Need help?
General
