EasyManuals Logo

KYMCO MXU 150 User Manual

KYMCO MXU 150
214 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
To start the engine without the electric starter
(MUX 150).
1. Follow steps 1 through 5.
2. With the throttle closed, operate the kick
starter with a rapid, continuous motion.
3. Follow steps 7 through 8.
If you cannot restart a warm engine:
1. Follow steps 1 through 4.
2. Open the throttle slightly (1/8 1/4) while
starting the engine . If the throttle limiter Is
adjusted as delivered, open the throttle fully.
Do not allow the kick starter to snap back
freely against the pedal stop as engine case
damage could result.
Raise the kick starter pedal after the kick
starter lever is returned to the stop.
CAUTION:
See the "engine break-in" section prior to
operating engine for the first time.
STARTING A WARM ENGINE
WARMING UP
To start a warm engine, refer to the "Starting a
cold engine" section. The choke knob should not
be used. The throttle should be opened slightly.
To get maximum engine life, always warm up the
engine before starting off. Never accelerate
hard with a cold engine! To see whether or not
the engine is warm, check if it responds to the
throttle normally with the choke knob turned off.
CAUTION:
70

Table of Contents

Other manuals for KYMCO MXU 150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KYMCO MXU 150 and is the answer not in the manual?

KYMCO MXU 150 Specifications

General IconGeneral
BrandKYMCO
ModelMXU 150
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals