Another way to remember the starting procedure is by using the acronym
B O N E C
BRAKES
LOCKED
IGNITION
SWITCH ON
NEUTRAL
TRANSMISSION
ENGINE
SWITCH
AUTOMATIC
CHOKE
NOTE: At this point if the engine
does not start, pump the primer
three more times; then press the
Active Riding
29
WARNING
Indicates a potential hazard that could
result in a serious injury or death.
BONE-C. It stands for:
Starting A Cold Engine
NOTE: It is very important not to
touch or compress the throttle
lever during the starting proce-
Turn off all electrical accessories
(hand warmer, lights, etc.); then
rotate the ignition switch key to the
first position (ON) leaving the
headlights OFF. Note that the N is
dures.
indicated on the LCD.
1.
the primer, the seat and right-side
NOTE: Pump the primer three
0 C (32 F) or colder. To access
heat shield must be removed.
times when the temperature is at
CAUTION
Allow 30 seconds between starting
attempts for the starter motor to
cool. Continuous starter motor
operation can result in overheating
the starter motor.
Press the starter button for eight
seconds maximum.
2.
If the engine does not start, press
the starter button again for eight
seconds.
3.
hesitating.
Allow the engine to warm up for
approximately 2-3 minutes or until
the ATV will accelerate without
4.
735-887C
738-436A
ACTIVE RIDING
starter button again.
To Next Page
Loading...
Need help?
General
