Before installing the battery, make
sure the ignition switch is in the
OFF position.
82
CAUTION
Taking the ATV out of storage and correctly
preparing it will assure many miles and
hours of trouble-free riding. KYMCO reco-
mmends the following procedure to prep-
are the ATV.
Clean the ATV thoroughly.
Clean the engine. Remove the cloth
from the exhaust system.
Check all control wires and cables
for signs of wear or fraying.
Replace if necessary.
Change the engine/transmission oil
and filter.
Charge the battery; then install.
Connect the battery cables making
sure to connect the positive cable
first.
1.
2.
3.
4.
5.
Check the entire brake systems
(fluid level, pads, etc.), all controls,
headlights, taillight, brakelight, and
headlight aim; adjust or replace if
necessary.
6.
Check the tire pressure. Inflate to
recommended pressure as neces-
sary.
7.
Tighten all nuts, bolts, cap screws,
and screws making sure all cali-
brated nuts, cap screws, and bolts
are tightened to specifications.
8.
Make sure the steering moves
freely and does not bind.
9.
Check the spark plug. Clean or
replace as necessary.
10.
Follow the recommendations found
in the pre-start inspection.
11.
PREPARATION AFTER STORAGE
To Next Page
Loading...
Need help?
General
