Excessive repetitive use of the
hydraulic brake for high speed
stops will cause overheating of the
brake fluid and premature brake
pad wear which will result in an
unexpected loss of brakes.
Use only KYMCO approved brake
fluid. Never substitute or mix dif-
ferent types or grades of brake
fluid. Brake loss can result. Check
brake fluid level and pad wear
before each use. Brake loss can
result in severe injury or even
death.
NOTE: The high range is for nor-
mal riding with light loads. The low
range is for carrying heavy loads
or trailer towing. Compared to
HIGH range, the LOW range posi-
tion provides slower speed and
greater torque to the wheels.
Active Riding
The KYMCO ATV with an automatic
transmission has a dual-range transmis-
sion with reverse. To shift the ATV, fol-
30
WARNING
Indicates a potential hazard that could
result in a serious injury or death.
Braking/Stopping
Always allow plenty of room and time
to stop safely. Sometimes quick stops
are inevitable, so always be prepared.
Whether you're stopping slowly or
stopping quickly, do this:
Squeeze the brake lever on the left
handlebar to apply both the front
and rear brakes.
1.
If your wheels lock, release them
for a second; then apply them
again.
2.
Never ride the brake. Even main-
taining minimal pressure on the
brake lever will cause the brake
pads to drag on the disc and may
overheat the brake fluid.
3.
WARNING
WARNING
Shifting
low these steps:
tral, move the shift lever forward.
To engage the high range from neu-
and forward.
To engage the low range from high
range, move the shift lever outward
1.
2.
CF130B
Low
High
Neutral
Reverse
To Next Page
Loading...
Need help?
General
