KYMCO MXU 375 User Manual

1.Direct the hose from the float bowl
drain into a container.
Do not drain float bowl contents
directly onto the engine. Gasoline
is highly flammable and could
ignite. Use a hose.
2.Loosen the drain screw and allow
the gasoline and condensation to
flow out.
3.Tighten the drain screw securely
and remove the hose.
It is very important that the drain sc-
rew be tightened securely. If it is not
tightened securely, gasoline could
drip onto the engine.
Do not overfill the engine with oil.
Always make sure the oil level is
above the “L”mark but not higher
than the“F” mark.
To remove the seat, lift up on the
latch release (located at the rear of
the seat); then raise the rear of the
seat and slide it rearward.
CARBURETOR FLOAT
BOWL DRAIN
OIL LEVEL STICK
SEAT LATCH
61
AF925
Periodically, the float bowl should be
drained to remove condensation. To
drain the float bowl, use the following
procedure.
WARNING
ATV-0100AA
There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.
NOTE: The ATV should be on
level ground when checking the
engine oil level.
Remove the oil level stick; the
engine oil level should be above the
“ L” mark but not higher than the
“F”mark.
Install the oil level stick and thread
it into the engine case.
1.
2.
3.
CAUTION
AL676A
1.
WARNING
GENERAL INFORMATION
Unstall the oil level stick and wipe
it with a clean cloth.
KC0051A
Oil Level Stick

KYMCO MXU 375 Specifications

General

Brand	KYMCO
Model	MXU 375
Category	Offroad Vehicle
Language	English