KYMCO MXU 375 User Manual

When replacing the headlight bulb,
be careful not to touch the glass
portion of the bulb. Grasp the new
bulb with a clean cloth.
Headlight
NOTE: The bulb portion of the
headlight is fragile. HANDLE WITH
CARE. When replacing the head-
light bulb, do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing. Skin oil
residue on the bulb will shorten
the life of the bulb.
Taillight/Brakelight
CHECKING/ADJUSTING
HEADLIGHT AIM
Position the ATV on a level floor so
the headlights are approximately
6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming sur-
face).
NOTE: There should be an aver-
age operating load on the ATV
when adjusting the headlight aim.
79
To replace the headlight bulb, use the
following procedure.
Remove the wiring harness connec-
tor from the back of the headlight.
Grasp the bulb housing, turn it
counterclockwise, and remove the
bulb.
Install the new bulb into the hous-
ing and rotate it completely clock-
wise.
Install the wiring harness connec-
tor.
1.
2.
3.
4.
CAUTION
To replace the taillight/brakelight bulb, use
the following procedure.
Rotate the socket counterclock-
wise and remove it from the hous-
ing.
To remove the bulb from the
socket, push in and rotate counter-
clockwise.
To install the bulb, push in and turn
clockwise.
Insert the socket into the housing
and rotate it clockwise.
1.
2.
3.
4.
The headlights can be adjusted verti-
cally and horizontally. The geometric
center of the HIGH beam light zone is
to be used for vertical and horizontal
aiming.
1.
Measure the distance from the floor
to the mid-point of each headlight.
Using the measurements obtained
in step 2, make horizontal marks on
the aiming surface.
Make vertical marks which inter-
sect the horizontal marks on the
aiming surface directly in front of
the headlights.
Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
Observe each headlight beam aim.
Prope r aim is when the most
intense beam is centered on the ver-
tical mark 5 cm (2 in.) below the
horizontal mark on the aiming sur-
face.
2.
3.
4.
5.
6.
ATV-0070
GENERAL MAINTENANCE

KYMCO MXU 375 Specifications

General

Brand	KYMCO
Model	MXU 375
Category	Offroad Vehicle
Language	English