5. FUEL SYSTEM
5-4
SUPER8 50
CARBURETOR REMOVAL
Remove the frame right side cover. (
Ö
2-4)
Disconnect the auto bystarter wire
connector.
Remove the met-in box. (
Ö
2-3)
Loosen the drain screw and drain the fuel
from the float chamber.
Disconnect the fuel tube and vacuum tube at
the carburetor.
Loosen the throttle cable adjusting nut and
lock nut, and disconnect the throttle cable
from the carburetor.
Loosen the carburetor intake manifold band
and air cleaner connecting tube band screws
and then remove the carburetor.
AUTO BYSTARTER
OPERATION INSPECTION
Measure the resistance between the auto
bystarter wire terminals.
Resistance:10Ω max. (10 minutes
minimum after stopping the engine)
If the reading is not within the limit, replace
the auto bystarter with a new one.
Adjustin
To Next Page
Loading...
Need help?
General
