KYMCO SUPER8 50 User Manual

5. FUEL SYSTEM
5-8
SUPER8 50
FLOAT CHAMBER
DISASSEMBLY
Remove the three float chamber screws and
the float chamber.
Loosen the float pin screw.
Remove the float pin, float and float valve.
Remove the main jet, needle jet holder,
needle jet, slow jet and pilot screw.
Clean the removed fuel jets with detergent
oil and blow them open with compressed
air.
Blow compressed air through all passages
of the carburetor body.
Pilot Screw
Float ValveFloa
t
Float Pin
Float Chambe
r
Slow Je
t
Main Je
t
N
eedle Jet Holde
r
N
eedle Je
t
Screws
• Be careful not to damage the fuel jets
and pilot screw.
• Before removing, turn the pilot screw
in and carefully count the number of
turns until it seats lightly and then
make a note of this.
• Do not force the pilot screw against its
seat to avoid seat damage.
＊

KYMCO SUPER8 50 Specifications

General

Brand	KYMCO
Model	SUPER8 50
Category	Scooter
Language	English