49
BRAKE PEDAL
Your KYMCO UTV is equipped with front and rear hydraulic
brakes that are activated simultaneously by the brake pedal.
Depress the brake pedal 1 to slow or stop the vehicle.
FEATURES & CONTROLS
22
22
2
11
11
1
ACCELERATOR PEDAL
(Throttle pedal)
Push the accelerator pedal 2 down to increase the engine’s
speed. Spring pressure will return the pedal to its original position
when foot pressure is released.
NOTE: Always check to make sure the accelerator pedal
returns normally before starting the engine. Make sure
there is adequate accelerator pedal free play before
starting the engine.
LOW
range
HIGH
range Neutral
Reverse
GEAR SHIFT LEVER
To change gears, stop the vehicle and allow the engine to idle,
then move the lever into the desired gear. Do not attempt to
shift gears if the engine speed is above idle or if the vehicle is
moving.
To Next Page
Loading...
Need help?
General
