53
FEATURES & CONTROLS
SEAT REMOVAL
The seats on your UTV500 can be removed from the chassis for
cleaning or service.
To remove the seat, pull up on the front edge of the seat to re-
lease its location pins from the chassis grommets.
To install the seat, slide the seats’ tabs into the corresponding
slots on the chassis and then press the front edge down until the
location pins are firmly seated into the grommets on the chassis.
SEAT BELTS
Your UXV500 is equipped with lap-shoulder seat belts for the
driver and the passenger. The seat belts are similar to the type
fitted to most automobiles and should be used by the driver and
passenger each time the UTV is driven
To secure the seat belt, insert the end tab into the latch until you
feel the latch mechanism “click” as it secures the tab.
To release the seat belt, press the release button on the seat belt
latch and pull the tab from the latch.
Never drive your UTV without fastining your seat belt.
Passengers should wear their seat belt any time the ve-
hicle is in motion. The shoulder portion of the seat belt is
designed to cross diagonally on the driver’s or passenger’s
torso. Failure to use the seat belt, or to use it properly,
may cause the driver or the passenger to be ejected from
the vehicle causing serious injury or death.
HEAD CUSHIONS
Your UXV500 has head cushions for the driver and the passenger
attached to the vehicle’s canopy.
To adjust a cushion’s location, remove the three screws that se-
cure the cushion to the canopy. Set the cushion to the desired
height and reinstall the screws, tightening them securely.
To Next Page
Loading...
Need help?
General
