EasyManuals Logo
Home>Kyocera>All in One Printer>FS-2100DN

Kyocera FS-2100DN User Manual

Kyocera FS-2100DN
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #236 background imageLoading...
Page #236 background image
Maintenance
7-2
Toner Container Replacement
The printer displays messages at two stages of toner usage:
When the printer becomes low on toner, the printer displays the message Toner is running out. as the first
caution. Note the replacement is not always necessary at this stage. Prepare the new toner kit.
If you ignore the above message and continue printing, the printer displays the message Replace the toner. - just
before the toner is used up. The printer will stop printing. The toner container must be replaced immediately. Refer to
Replacing the Toner Container on page 7-3.
Frequency of Toner Container Replacement
The life of the toner containers depends on the amount of toner required to accomplish your printing jobs. According to ISO/
IEC 19752 and EcoPrint switched off the toner container can print as follows (A4/Letter paper is assumed):12,500 images
(FS-2100D and FS-2100DN), 15,500 images (FS-4100DN), 21,000 images (FS-4200DN for the U.S.A.) or 25,000 images
(FS-4200DN for destination other than the U.S.A. and FS-4300DN).
Starter Toner Container
The toner container packed with the new printer is a starter toner container. The starter toner container lasts an average of
6,000 images (FS-2100D and FS-2100DN), 8,000 images (FS-4100DN) , or 10,000 images (FS-4200DN and FS-4300DN).
Toner Kits
For best results, we recommend that you only use genuine Kyocera Parts and Supplies. Should any damage be caused by
the application of a toner other than the original toner, then this damage is excluded from the guarantee.
A new toner kit contains the following items:
Toner Container
Plastic waste bags for old toner container and old waste toner box
Waste Toner Box
Installation Guide
Note Information Collection on Memory Chips - The memory chip attached to the toner container is designed to
improve convenience for the end user; to support the recycling operation of empty toner containers; and to gather
information to support new product planning and development. The information gathered is anonymous - it cannot
be associated to any specific individual and the data is intended to be used anonymously.
Note Do not remove the toner container from the carton until you are ready to install it in the printer.

Table of Contents

Other manuals for Kyocera FS-2100DN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera FS-2100DN and is the answer not in the manual?

Kyocera FS-2100DN Specifications

General IconGeneral
BrandKyocera
ModelFS-2100DN
CategoryAll in One Printer
LanguageEnglish

Related product manuals