To Next Page

To Previous Page

7. Setup Mode: Channel Configuration

This chapter explains how to configure the serial port.

Channel 1 (Option 1) or Channel 2 (Option 2)

Select Channel 1 (option 1) or Channel 2 (option 2) from the Change Setup menu to

define how the serial port responds to network and serial communications. The

following sections describe the configurable parameters within the Channel

configuration menu.

Figure 7-1. Serial Port Parameters

Baudrate (9600) ?

I/F Mode (4C) ?

Flow (00) ?

Port No (10001) ?

ConnectMode (C0) ?

Send '+++' in Modem Mode (Y) ?

Show IP addr after 'RING' (Y) ?

Auto increment source port (N) ?

Remote IP Address : (000) .(000) .(000) .(000)

Remote Port (0) ?

DisConnMode (00) ?

FlushMode (00) ?

DisConnTime (00:00) ?:

SendChar 1 (00) ?

SendChar 2 (00) ?

Baudrate

The unit and attached serial device, such as a modem, must agree on a speed or

baud rate to use for the serial connection. Valid baud rates are 300, 600, 1200, 2400,

4800, 9600 (default), 19200, 38400, 57600, 115200, and 230400 bits per second.

xPico also supports high-performance baud rates of 460800 and 921600 bits per

second. (See CPU Performance on page 55).

Baudrate (9600) ? _

xPico User Guide 40

Lantronix xPico User Manual

Other manuals for Lantronix xPico