7: Setup Mode: Channel Configuration
b) Response
A single character is transmitted to the serial port when there is a
change in connection state:
C = connected, D = disconnected, N = host unreachable.
The IP address of the host connecting to the CoBos device will
be provided when you use verbose mode.
This option is overridden when the Active Start Modem Mode
or Active Start Host List is in effect. Default setting is Nothing
c) Active Startup
Does not attempt to initiate a connection under any
circumstance. Default setting.
Attempts to connect when any character is received from the
serial port.
With active Modem
Control In
Attempts to connect when the Modem Control In input changes
from not asserted to asserted.
With a Specific Start
Character
Attempts to connect when it receives a specific start character
from the serial port. The default start character is carriage return.
xPico User Guide 44
To Next Page
Loading...
Need help?
General
