CAUTION
Operating the product with connecting cables attached at only one of
their two ends
If the product is operated with connecting cables attached at only one of
their two ends, for example external supply cables, interface cables, the per-
mitted level of electromagnetic radiation may be exceeded and the correct
functioning of other products may be impaired.
Precautions:
▶
While the product is in use, connecting cables, for example product to
external battery, product to computer, must be connected at both ends.
1.8 FCC Statement, Applicable in U.S.
WARNING
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environ-
ment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his
own expense.
WARNING
Changes or modifications not expressly approved by Leica Geosystems for
compliance could void the user's authority to operate the equipment.
007506_003
Power: 48V DC, 100VA max.
T2 AH, 400V Rev.:2.0
Leica Geosystems AG
CH-9435 Heerbrugg
Manufactured:
Made in Switzerland
This device complies with part 15 of the FCC Rules. Operation is
subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) this device mus accept any interference received, including
interference that may cause undesired operation.
T-Scan Controller Rev. 2.0
819828
CTL2000000
Model:
Art.No.:
S.No.:
08.2017
To Next Page
Loading...
Need help?
General
