Page 46
III−START-UP
A−Preliminary and Seasonal Checks
1 − Inspect electrical wiring, both field and factory installed for
loose connections. Tighten as required.
2 − Check voltage at disconnect switch. Voltage must be
within range listed on the nameplate. If not, consult the
power company and have voltage condition corrected
before starting unit.
3 − Inspect condition of condensate traps and drain as-
sembly. Disassemble and clean seasonally.
B−Heating Start-Up
FOR YOUR SAFETY READ BEFORE LIGHTING
CAUTION
Shock and burn hazard.
G32V units are equipped with the SureLight igni-
tion system. Do not attempt to light manually.
WARNING
Do not use this furnace if any part has been under-
water. Inspect the furnace and replace any part of
the control system and any gas control which has
been under water.
WARNING
If overheating occurs or if gas supply fails to shut
off, shut off the manual gas valve to the appliance
before shutting off electrical supply.
CAUTION
Before attempting to perform any service or main-
tenance, turn the electrical power to unit OFF at
disconnect switch.
BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
Use only your hand to turn the gas control switch. Never
use tools. If the switch will not turn by hand, do not try to re-
pair it, call a qualified service technician. Force or at-
tempted repair may result in a fire or explosion.
G32V units are equipped with the SureLight ignition system.
DO NOT attempt to manually light burners on this furnace.
Each time thermostat calls for heat, burners will be automati-
cally lit. The ignitor does not get hot when there is no call for
heat on units with SureLight ignition system.
How To Operate Gas Valve (Figure 50)
WARNING
If you do not follow these instructions exactly, a
fire or explosion may result causing property
damage, personal injury or loss of life.
1 − STOP! Read the safety information at the beginning of
this section.
2 − Set thermostat to lowest setting.
3 − Turn off all electrical power to furnace.
4 − This appliance is equipped with an ignition device
which automatically lights the burner. Do not try to light
the burner by hand.
5 − Remove unit access panel.
6 − WhiteRodgers natural valve, move lever to OFF.
WhiteRodgers propane and Honeywell valve, turn
knob to OFF. Do not force. See figure 50.
7 − Wait five (5) minutes to clear out any gas. If you then smell
gas, STOP! Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s instructions. If
you do not smell gas go to next step.
FI
RE
White Rodgers
LP Gas Valve
White Rodgers
Natural Gas Valve
Honeywell Nat / LP Gas Valve
VALVES SHOWN IN
OFF POSITION
8 − WhiteRodgers natural valve, move lever to ON. WhiteR-
odgers propane and Honeywell valve, turn knob to ON.
Do not force.
9 − Replace access panel.
10− Turn on all electrical power to unit.
11− Set thermostat to desired setting.
To Next Page
Loading...
Need help?
General
