1
2
3
4
5
6
7
Terminal Voltage (V dc)
2 + 0 to + 14.4
6 Ground (−)
3. If the voltage is less than +14.4 V dc, the battery pack has been discharged.
Note: Recharging will take at least 3 hours, even if the indicator does not turn
on.
If the voltage is still less than +14.4 V dc after recharging, replace the battery.
4. If the voltage is more than +14.4 V dc, measure the resistance between battery
terminals 4 and 5. The resistance must be 4 to 30 K .
If the resistance is not correct, replace the battery pack. If the resistance is
correct, replace the system board.
Checking the backup battery
Do the following:
1. Power off the computer, and unplug the ac adapter from it.
2. Turn the computer upside down.
3. Remove the battery pack (see “1010 Battery pack” on page 60).
4. Remove the backup battery (see “1140 Backup battery” on page 82).
5. Measure the voltage of the backup battery. See the following figure.
Red (+)
Black (-)
Wire Voltage (V dc)
Red +2.5 to +3.2
Black Ground
v If the voltage is correct, replace the system board.
v If the voltage is not correct, replace the backup battery.
v If the backup battery discharges quickly after replacement, replace the system
board.
Checkout guide
36 ThinkPad
®
X60, X60s, X61, and X61s
To Next Page
Loading...
Need help?
General