6
BA33.0001 EN 2.0
What is new / what has changed in the Operating Instructions?
Material number Edition Important Contents
00 408 498 1.0 03/99 TD09 1st edition First printing
00 465 520 1.0 03/03 TD09 1st edition
replaces 408 498
Completely revised
13055270 2.0 06/05 TD09 1st edition
replaces 465 520
Supplement: Gearbox and brake data; Connection of
incremental encoder; Example for function block
interconnection
Safety instructions
Hazardous v oltage on the power connections even when disconnected from mains: residual voltage >60 V!
When carrying out work on the power connections always disconnect the controller from the mains and wait
until the motor is at standstill (voltage at the contacts when the motor is rotating).
Danger of burning!
During operation, surfaces temperatures of up to 140 °C are possible.Protect against contact!
Danger of injury through rotating shaft!
Before working on motor, ensure motor is at standstill.
Never disconnect from mains when energised!
Otherwise, plug can be destroyed. I nhibit controller b efore disconnecting from the mains.
Mounting
Read these operating instructions before you start!
z
Use an appropriate means of transport and lifting equipment!
z
The shaft must not b e exposed to knocks or bumps! Motor can be destroyed! Drive elements must be mounted
on the motor shaft v ia the threading. An extracting device must be used when dismounting. Fasten coupling
securely.
z
Fasten motor and ensure unimpeded ventilation
z
If necessary, open condensation drain holes
z
Tighten coupling ring of connector
z
Motor must be carefully earthed , check cabling
z
Extensive shielding of motor cable on motor and controller
z
Maintenance interval for shaft sealing ring: approx. 2500 h
z
Maintenance interval for ball bearings: approx. 15000 h
z
Remove dirt at regular intervals
X
Tip!
Current documentation and software updates for Lenze products can be found on the
Internet in the ”Downloads” area under
http://www.Lenze.com
© 2005 Lenze Drive Systems GmbH, Hans-Lenze-Straße 1, D-31855 Aerzen
No part of this documentation may be reproduced or made accessible to third parties without written consent by Lenze Drive
Systems GmbH.
All information given in this documentation has been selected carefully and complies with the hardware and software described.
Nevertheless, deviations cannot be ruled out. We do not take any responsibility or liability for damages which might possibly occur.
Necessary corrections will be included in subsequent editions.
To Next Page
Loading...
Need help?
General
