USING YOUR SMART HUMIDIFIER
1. Plug in the humidifier. Press to turn
your humidifier on. The humidifier will
automatically begin misting on high
for 3 seconds, then change to the low
mist setting.
2. Tap repeatedly to cycle through mist
settings: Auto Mode, Low, and High.
Figure 3.1
3. Rotate the nozzle to adjust the direction
of the mist. Figure 3.2
4. When your room has reached your
preferred humidity level, turn the
humidifier to a lower setting, or turn it
o. A healthy humidity level is between
40% and 50%. Figure 3.3
5. Press to turn your humidifier o.
Figure 3.1
Figure 3.2
Figure 3.3
Note:
Using the VeSync app allows you to control
your smart humidifier remotely and access additional
functions and features (see page 13).
Note:
You can also use Auto Mode to keep
the humidity level between 40% and 50%.
Note:
If there is no water in the tank,
will
flash 10 times, and the humidifier will turn o. Fill
the water tank (see Getting Started, page 9).
Note:
• The humidifier will not mist in Auto Mode
if the humidity level is above 50%. If
you want the humidifier to keep misting,
change the mist setting, or change the
Auto Mode settings in the VeSync app.
• For more information about Auto Mode,
see page 13.
Note:
• If there is no water in the tank, the
humidifier will stop misting, will flash
10 times, and the humidifier will turn o.
Refill the tank and properly place it on
the base to use your humidifier.
• If the water tank is removed, will
remain on until the tank is replaced.
EN
12
To Next Page
Loading...
Need help?
General
