CONTROL PANEL
TOP COVER
1.
Remove the 2 screws on the rear panel.
2.
Lift and disassemble the rear panel frome the top
cover assembly.
1.
Remove the 2 screws on the top plate that hold the 2
plastic holders.
2.
Lift the 2 plastic holders and slide it forward to clear
the 3 tabs
3.
Lift the top plate.
1.
Romove the 3 screws on the front panel assmbly.
2.
Remove the 5 screws on the PCB assembly from
the back of the front panel assembly.
3.
Disassemble the front panel assembly.
WARNING!
When you disassemble the Dryer, be sure to
disconnect the dryer from its electrical supply.
Protect your hands and arms from sharp edges
when working. To reduce the risk of personal
injury, adhere to all industry recommended
safety procedures including the use of long
sleeved gloves and safety glasses.
The inner top plate is held in place by 2
screws(1 on each side) and the 2 plastic holders.
3.
Remove the 3 screws that hold the top cover in
place.
4.
Lift the top cover and slide it forward to clear the
front tabs.
31
TOP PLATE
To Next Page
Loading...
Need help?
General
