52
PROGRAMMING MODE - SETUP MODE
19. Rinsing time setup
Rinsing time setup can be used to set the time for each rinse.
Enter setup mode.
You will see LqC1
Button Display
Press the
Hot
button.
Press the
Warm
or the
Cold
button until appears
in the display.
Press the
Start
button.
Press the
Warm
or the
Cold
button until appears
in the display.
Press the Start button. Display .
Press Warm or Cold button to select course.
: Hot course
: Warm course
: Cold course
: Delicates course
: None (only for Heater model)
Press the
Start
button.
Display previous rinsing time.
Press
Warm(+)
or
Cold(-)
button to select rinse cycle.
(Max 16min, Min 9min)
Press the
Start
button.
The machine sets up the rinsing time, then advances to
the next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the Hot button three times.
To Next Page
Loading...
Need help?
General
