53
PROGRAMMING MODE - SETUP MODE
20. Top spin speed – final spin time depends on RPM
Top spin speed setup can be used to set the maximum spin RPM.
NOTE
• Top spin speed
0 : 1150 rpm
1 : 1000 rpm
2 : 900 rpm
3 : 800 rpm
4 : 700 rpm
5 : 600 rpm
6 : 500 rpm
Enter setup mode.
You will see LqC1
Button Display
Press the
Hot
button.
Press the
Warm
or the
Cold
button until appears
in the display.
Press the
Start
button.
Press the
Warm
or the
Cold
button until appears
in the display.
Press the Start button. Display .
Press Warm or Cold button to select course.
: Hot course
: Warm course
: Cold course
: Delicates course
: None (only for Heater model)
Press the
Start
button.
Display previous top spin speed.
Press
Warm(+)
or
Cold(-)
button to select top spin
speed. (Refer to NOTE below for Top spin speed.)
Press the
Start
button.
The machine sets up the top spin speed, then advances
to the next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the Hot button three times.
To Next Page
Loading...
Need help?
General
