To Next Page

To Previous Page

- 31 -

4.4 Vacuum Mode

This function is used for creating vacuum in the system after compressor replacement, ODU parts replacement

or IDU addition/replacement.

4.5 Static pressure compensation mode

This function is used for creating vacuum in the system after compressor replacement, ODU parts replacement

or IDU addition/replacement.

Service PCB DIP switch on : No.5

Start the vacuum mode : “VACC”

ODU V/V open

ODU EEV open

IDU EEV open

Vacuum mode setting method

Vacuum mode cancellation method

Push the reset button on Master unit PCB

Select the mode using

‘ȯ’, ‘ȭ’ Button : “SVC”

Push the ‘●’ button

Select the Function using ‘ȯ’, ‘ȭ’ Button : : “Se3”

Push the ‘●’ button

Service PCB DIP switch on : No.5

Select the mode using ‘ȯ’, ‘ȭ’ Button : “Func”

Push the ‘●’ button

Select the Function using ‘ȯ’, ‘ȭ’ Button : “Fn2”

Push the ‘●’ button

Select the Option using ‘ȯ’, ‘ȭ’ Button : : “op1~op3”

Push the ‘●’ button

Start the Static pressure compensation mode :

Save the selected option value in EEPROM

CAUTION

ODU operation stops during vacuum mode. Compressor can't operate.

Static pressure compensation mode setting method

Function

LG Multi V Service Manual

Other manuals for LG Multi V