3. Installation
HDMI-TPS-TX226
DIFFERENCE:
▪
▪
▪
A
Using local PSU
.
B
you will need
C
Using Remote Power (12V over TPS) from HDMI-TPS-RX96
Important Notes when Remote Powering the HDMI-TPS-TX226
Cabling
▪ prevent ground potential difference.
▪ The maximum transmission distance may be limited. Maximum recommended cable length is 30m.
▪ The CATx cable must not be cut or crimped when it is connected
Ground loop
▪
▪ The CATx cable should run on a similar path as the power lines and safety ground wire
▪ The connected source and sink devices at the two endpoints should have the same Earth potential
▪
cause audible noise
Di-Box (audio balun) on the audio input, or to use the balanced audio input
To Next Page
Loading...
Need help?
General