D9U001GE4-0101_05
25
8.5 Before Use
Prepare the bed for use as follows:
► Connect the bed to the mains.
► Charge the accumulator.
► Raise and tilt the mattress support platform to the highest position.
► Lower and tilt the mattress support platform to the lowest position.
► Check that the castors as well as main brake work correctly.
► Check that the bed extension works correctly.
► Check that it is possible to remove the head and foot boards.
► Check all of the functions on the control elements.
► Check that the siderails function properly.
► Dispose of all packaging (see Disposal).
8.6 Transport
For a safe transport, observe the following:
► Ensure that no cables are run over when moving a bed.
► Ensure that the mains cable is attached with a hook (at the head end of the bed).
► Ensure that the castors are unlocked before moving the bed during the loading/unloading process (see Castor Control).
► Adjust bed height to at least 20 cm below maximum height.
► Push bed by handles on head or foot end.
► Move the bed exclusively on suitable oor surfaces.
► For longer distances, ensure that the castor steering function is activated.
► Ensure that the brakes are released while moving the bed.
Suitable surfaces:
■ Tile
■ Hard linoleum
■ Poured ooring
Unsuitable surfaces:
■ Too soft, unsealed or defective ooring
■ Soft wooden ooring
■ Soft and porous stone oors
■ Carpeted oors with underlay
■ Soft linoleum
To Next Page
Loading...
Need help?
General
