Linksys E2000 Configuration Guide

Linksys® E2000 Wireless-N Router Configuration Guide
Page 16 Revision 1.1
2.7 Adding a Wireless PC N2KView Client to the Network
Using the Wireless Configuration programs supplied with the PC, connect to the Wireless
Network identified by the SSID written on the label affixed to the bottom of your router. When
prompted to enter the passphrase, enter the passphrase from the same label. If requested to
enter the type of security used by the wireless network, select the option WPA/WPA2.
Open the Connections Dialog by clicking on the Connections tab on the right of the screen.
In the N2KServer Connection section, press the Disconnect button, type the IP address of the
IPG100 or PC-based N2KServer.
If the default values are used this should be 192.168.1.3. A message should be displayed at
the bottom left of the section stating that an IPG100 or N2KServer has been found, and giving
its IP Address.
Press the Connect button to establish the connection.
2.8 Adding a Mobile N2KView Client to the Network
Mobile N2KView Clients may be iPads, iPhones, Android Smart phones etc.
Using the Wireless Configuration programs supplied with the device, connect to the Wireless
Network identified by the SSID written on the label affixed to the bottom of your router. When
prompted to enter the passphrase, enter the passphrase from the same label. If requested to
enter the type of security used by the wireless network, select the option WPA/WPA2.
In N2KView Mobile, press the Menu button at the top of the screen, and then the Settings
button to enter the Setting dialog. Type the IP address of the IPG100 or PC-based N2KServer.
If the default values are used this should be 192.168.1.3.
Press the Connect button to establish the connection.

Linksys E2000 Specifications

General

Ethernet LAN	Yes
Networking standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3ab, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
Input current	1 A
Input voltage	12 V
Dimensions (WxDxH)	202 x 34 x 160 mm
WLAN data transfer rates supported	300 Mbit/s
DHCP client	-
Antennas quantity	3
Antenna gain level (max)	2.2 dBi
Web-based management	No
Security algorithms	WEP, WPA, WPA2
Certification	FCC, CE, IC-03, Wi-Fi
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %
Cables included	LAN (RJ-45)

Weight and Dimensions

Weight	300 g