Lippert Components Solera Classic User Manual

8
lci1.com 574 - 537- 890 0 Rev: 11.16.18
Solera
®
Classic Awning
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0001254
Extending the Awning
1. Make sure the black locking knobs on the mount/rafter arm
upper channels (Fig.6, Channel #3) are loosened. Pinch the
travel locks together to release the outer arm from the mount/
rafter arm.
2. Flip cam lock down to the extend position.
3. Using the pull rod, start pulling the awning outward until full
extension is complete.
4. Slide the mount/rafter arms all the way to the top of the
outer arm. Make sure they lock into place.
5. Pull on the mount/rafter arm to ensure the fabric is taut, then
tighten the black locking knob to lock it into place.
6. Raise the outer arms to the desired height by releasing
the support arm assembly handle and allow the outer arm
upper channel (Fig.6, Channel #1) to slide onto the outer
arm lower channel (Fig.6, Channel #1). After the desired
height is reached let go of the support arm assembly
handle to lock the arm at this position.
7. Repeat steps 4-6 on the other end.
8. Slide the pull strap to one end or the other and wrap it
around the arm to get it out of the way.
Installing the Stop Bolt
1. Make sure the awning is completely retracted.
2. Make sure the roll tube centerline is level with or slightly
higher than the awning rail centerline (Fig.1). The bottom of
the roll tube MUST not be higher than the awning rail.
3. Adjust support arm assemblies if necessary.
A. Open the outer arm handle (Fig.11) and slide the outer
arm upper channel (Fig.6, Channel #1) up or down to the
desired height.
B. Close the handle and slide the outer arm upper
channel (Fig.6, Channel #1) on the outer arm lower
channel (Fig.6, Channel #2) until the locking pin clicks
into the nearest positioning hole.
4. With a non-permanent method of marking, mark the
position of the stop hole that is directly below the outer arm
upper channel (Fig.6, Channel #1).
5. From the inside of the outer arm lower channel
(Fig.6, Channel #2), insert a 5/16” bolt through the hole.
Secure with a star washer and a 5/16” acorn nut using ½”
socket and wrench (Fig.12).
NOTE: It may be necessary to lift the outer arm upper
channel (Fig.6, Channel #1) to tighten the acorn nut.
6. Repeat steps 3-5 for the other support arm.
Fig.12
Bolt
Star Washer
Acorn Nut
Fig.11
Support Arm
Assembly
Handle
Operation

Lippert Components Solera Classic Specifications

General

Brand	Lippert Components
Model	Solera Classic
Category	Automobile Accessories
Language	English