- 25 -
PEAK
By keeping the PEAK input closed the maximum weight value reached remains displayed. By
opening the input the current weight is displayed.
If you wish to use this input to view a sudden variation peak, set the FILTER ON THE
WEIGHT to 0.
ANALOG OUTPUT (TLB4 ONLY)
- : it selects the analog output type (4÷20 mA, 0÷20 mA, 0÷10 V, 0÷5 V, ±10 V, ±5 V;
default: 4÷20 mA).
For the output ±10 V and ±5 V a soldered jumper must be closed:
▫ open the instrument;
▫ locate in the printed circuit board the soldered jumper highlighted in the picture below:
▫ close the jumper shorting the pads with a drop of tin.
- : choice of a weight followed by the analog output: gross () or net (). If the net
function is not active, the analog output varies according to gross weight.
- : set the weight value for which you wish to obtain the minimum analog output value.
Only set a value different from zero if you wish to limit the analog output range; for
instance: for a full scale value of 10000 kg you require an 4 mA signal at 5000 kg and
20 mA at 10000 kg, in this case, instead of zero, set 5000 kg.
- : set the weight value for which you wish to obtain the maximum analog output value; it
must correspond to the value set in the PLC program (default: calibration full scale). E.g.: if I am
using a 4÷20 mA output and in the PLC program I wish to have 20 mA = 8000 kg, I will set the
parameter to 8000.
+
To Next Page
Loading...
Need help?
General