17
5. Press the
buttons to select your desired language to be
displayed on the menu. The default on-screen menu language is
set as English. Press the OK button to confirm.
Initial Setup
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the AERIAL IN socket at the rear right bottom view of
your TV.
Do not connect the TV to the mains
supply until you have completed all the
connections.
COAX
Audio Out
AERIAL IN
USB
HDMI CI CARD IN
RF coaxial cable
(not included)
OR
2. Connect the mains adapter to the mains socket after you
have completed all the connections. At this stage, the
TV switches to standby mode. The red LED indicator will
illuminate on the front panel of the TV.
3. In standby mode, press the STANDBY button on the
front right side panel of the TV or the
button on
the remote control to turn the TV on. The red LED
indicator will turn blue.
• Only use the included mains adapter. Do not use
it with any other equipment.
• Always disconnect the TV from the mains socket
when not in use for a long period of time.
• The STANDBY button on the front right side
panel of the TV or the
button on the remote
control is only used for switching the TV into
standby, it does not disconnect the TV from
the mains power. To completely disconnect the
mains power, please remove the mains adapter
from the mains socket.
VGA (PC)
DC IN
VGA (PC)
Audio In
Mini YPbPrCVBSSCART R L
To the mains
socket
4. The first time you turn the TV on, it will go straight into the First Time
Installation menu. Please ensure the aerial is plugged in and then press
the OK button. (If you have already installed the TV using the Quick Start
Guide, please go to the section “Selecting the Input Source” on the next
page.)
Please select an OSD Language
Deutsch
Español Français
Português Italiano
English
Please ensure aerial is plugged in!!
Then press OK button to start
L22FEDN_P_R_W12_IB_120402_Annie.indd 17 12年4月2日 下午3:16
To Next Page
Loading...
Need help?
General
