Lombardini 15 LD 315 User Manual

57
DATE
22.12.2003
COMPILER TECO/ATI
REG. CODE
1-5302-467
MODEL N°
50707
DATE OF ISSUE
06-95
REVISION 05
ENDORSED
115
X
FUEL SYSTEM
Static injection lead test on flywheel
Fill the tank and make sure that the fuel is not more than 10-15 cm
above the tester. Set the flow governor lever of the injection pump in
the stop position and lock it there.
Turn the flywheel in the engine rotation direction. proceed slowly
during the compression phase. The fuel that flows from tube 2 will
tend to diminish. Stop as soon as it creases to drip (one drop of
fuel every 30-40 seconds is tolerated): this is the static injection
lead. Make sure that B coincides with A.
See fig. 117-118 if B does not coincide with A.
Use a temporary tank if the engine is not fitted with one. Here again, it is essential to make sure that the fuel level is
no more than 10-15 cm above the injectionm pump.
References on the flywheel
A = Reference of fixed TDC on crankcase
B = Injection lead reference on the flywheel
C = TDC reference on flywheel
αα
αα
α = Reference in degrees between B and C.
When B coincides with A, the piston is in the static injection lead position. When C coincides with A, the piston is at top dead
center.
epytrotoM
mmC/B
αα
α
αα
lanretxehtiw
leehwylfØ
022
lanretxehtiw
leehwylfØ
032
lanretxehtiw
leehwylfØ
042
lanretxehtiw
leehwylfØ
062
522DL51
dradnats
44÷0464÷2432÷12
522DL51
]mpr[0051otpudedrocer
5,23÷9243÷0371÷51
522DL51
]mpr[0022ot0051morfdedrocer
83÷5,4304÷6302÷81
053/513DL51
erutcevinimdnadradnats
05÷6425÷8452÷32
053/513DL51
stesgnitarenegfoorpdnuoS
44÷0464÷2422÷02
053/513DL51
]mpr[0051otdedrocer
04÷6324÷8302÷81
004DL51
]mpr[0063otdedrocer
84,9231
004DL51
]mpr[0003otdedrocer
59,4211
APE004DL51
]mpr[0063otdedrocer
53,825,21
APE004DL51
]mpr[0003otdedrocer
59,4211
044DL51
]mpr[0063otdedrocer
57,1341
044DL51
]mpr[0003otdedrocer
12,7221

Lombardini 15 LD 315 Specifications

General

Brand	Lombardini
Model	15 LD 315
Category	Engine
Language	English