(5) Driving tractor on the road
When facing downhill, DO NOT place the gear lever in NEUTRAL position.
When driving the tractor on a unpaved road by attaching an implement to 3-point linkage, place the
gear lever to low speed and DO NOT lift the implement up to the highest position. When the tractor
bumps an obstacle, it may cause the jolting of the implement and the failure of hydraulic system.
(In this case, place the position control lever on ¾ rising position of full stroke for safety.)
Position control lever
▶
Connect the left/right brake pedal with brake pedal connecting pin before driving (if
fitted).
Avoid a sudden start, sudden brake and sudden turning.
Avoid a sudden start, sudden brake and sudden turning.
▶
DO NOT allow people on the tractor or on other implements.
▶
DO NOT place the baggage on the tractor or implement.
▶
Place PTO gear lever in NEUTRAL position and put the PTO switch in OFF
position.
▶
DO NOT use the differential lock and four wheel drive (2WD use only).
▶
When traveling with implement on rear 3-point linkage, tighten the stabilizer to
avoid lateral movement.
▶
When traveling with implements installed, turn slowly by wide turning radius.
▶
While traveling, DO NOT ride your foot on the clutch pedal (if fitted) or brake pedal.
▶
While traveling, DO NOT operate any implement such as tiller, loader etc.
Caution
To Next Page
Loading...
Need help?
General
