▶
When engine oil is warm, the
impurities can be drained
completely.
Notice
①
①①
① Drain Engine oil
Run engine for a few minutes to warm oil
Park the tractor on a level surface.
Remove drain plug of oil pan and drain the oil
completely.
5-8. Every 300 hour check
(1) Replacing Engine oil and Filter
Engine oil
gauge
Oil filling inlet
Engine oil filter
②
②②
② Replace Engine oil filter
Clean carefully around the filter.
Coat clean engine oil on the packing of new filter
and check the packing is placed well in the groove.
Turn the oil filter counter-clockwise to remove with
filter wrench.
Turn the new filter clockwise to assemble until the
packing makes contact with the mounting surface.
Tighten clockwise from ¾ to 1 turn more after
packing contact.
If the metal is attached to the element of oil filter to
be disassembled, contact your authorized dealer.
③
③③
③ Fill Engine oil
40± 5 N.m) (29.5± 5 lbs-ft)
Add engine oil as its capacity and check the oil
level is between low and high marks of the oil
gauge. For oil specification, refer to the section,
Lubricants and Capacity, at the end of this
manual. (or, See page 5-5)
Check any leakage of the engine while running
the engine for several minutes at idle rpm.
Stop the engine. After about 5~10 minutes later,
check again the oil level is between low and high
marks of the oil gauge.
Install the oil gauge.
Close
Open
Packing
To Next Page
Loading...
Need help?
General
