H/W INSTALLED: Up to four Delta cards may be installed in a system at one
time. (Note: this option may not exist in the Delta software drivers at the time
of the first release.) This section displays all installed Delta cards, and allows
you to select which particular card is under the control of the control panel
software. To select a card for configuration, click the radio button to the left of
that particular card in the “H/W Installed” list.
ON THE MAC: To save your Delta control Panel settings, go to the File menu
and select “Save,”or “Save as.” A dialog box will appear, promting you to name
the current configuration. Once you have done so, click the Save button. To save
the current settings as your default, go to the File menu and choose “Save as
Preferences.”
In the upper righthand corner of the control panel is a “H/W Installed” drop-
down list. At the time of this writing, the Delta Mac ASIO drivers will support
only a single Delta device, and of course the sound Manager will support only
one stereo pair regardless of how many audio cards are installed in your system.
The H/W Installed list will display “Delta 1010 as the active device in the control
panel”.
Delta 1010 Recording Tutorials
In this section we will explore a few sample setups for recording and playback
using the Delta 1010 Digital Recording System. This is by no means an
exhaustive tutorial but its intent is to help you understand most of the Delta
1010’s feature set. Before beginning, you should open your music software and
profile the Delta 1010, enable its drivers, or otherwise setup the software for
operation with the Delta 1010.
NOTE: All of these examples refer to the Windows MME driver
names. If you’re using ASIO drivers, you’ll need to substitute the
appropriate driver names when referring to software inputs or
outputs.
Typical Setup #1
Let’s assume for this setup that we’re recording a guitar and vocal, then
overdubbing another guitar and vocal track while listening to the first tracks.
The following diagram shows a microphone pre-amp and direct box being used
(in this case, the Audio Buddy™ by Midiman), and a stereo sound system. The
pre-amp and direct box are required for the mic and guitar. Many instruments,
such as MIDI modules or keyboards, may be connected directly to the Delta
1010’s inputs.
28
To Next Page
Loading...
Need help?
General
