column, select the radio button named "S/PDIF In." This will copy all S/PDIF
input audio directly over to the analog outputs – therefore in this example, the
monitor mixer will be completely bypassed. Once this assignment is made,
you may play the DAT material at any time and verify that it is making it into
the Delta 1010 successfully. This can be done regardless of whether or not
your recording software is open.
6. Within your recording software, select "S/PDIF In Delta-1010," as the audio
input device. The Delta input appears as a stereo pair.
7. Start your software recording and then start your DAT material playing. You
should be able to hear the DAT material through your sound system.
Transferring from 1010 to DAT, monitoring with DAT
1. Connect the Delta 1010’s S/PDIF Out to the DAT’s coaxial S/PDIF Input
using a good quality cable.
2. Connect the DAT analog outputs to some type of amplified sound system.
The sound system should be equipped with speakers or headphones.
3. Because you will be playing back at the recorded sample rate, you will want
to set the Delta 1010’s master clock to use the 1010 internal crystal. Do this by
To Next Page
Loading...
Need help?
General
