31
Engine
Service Instruction for Air Cleaner Service
1. Remove oil bowl of air cleaner and drain
entire oil.
2. Remove primary & secondary wiremesh
element & clean them with diesel.
3. Remove foam element clean it in diesel and
squeeze it to remove dirt.
4. Apply 6 to 8 gms of oil uniformly on the
surface of foam.
5. Clean housing from inside and place foam
inside.
6. Completely clean top and bottom filter
element, dry them with compressed air and
put in to filter.
7. Fill the oil bowl up to oil filling mark and
assemble it in to main body.
8. Check for perfect assembly.
9. Check the seal for perfect sealing condition
and replace it if necessary.
Care Required While Assembling Crank Shaft
Loctite 5060 needs to be applied on the face of the Gear for Counter weight
at Crankshaft - 006009900B1, as highlighted in the images.
To Next Page
Loading...
Need help?
General