Hand tool storage pocket
The table saw comes with
a
hand tool
storage pocket in the base. Keep wrenches,
screwdriver, etc. in this pocket.
Adjusting depth
of
cut
The depth
of
cut may be adjusted by turn-
ing the knob. Turn the knob clockwise
to raise the blade
or
counterclockwise to
lower
it.
The depth
of
cut
is
indicated on
the scale by the pointer
(A).
If
the knob does not turn easily, loosen the
two adjusting screws on the inside
of
the
table saw counterclockwise.
If
the knob
is
loose enough to be turned by vibration,
tighten the adjusting screws clockwise.
I
1
14
To Next Page
Loading...
Need help?
General
