Movement and transport
of
table saw
Before moving the table saw, tighten the
wing bolt to secure the sliding table.
When moving the table saw, hold
it
by the
fixed table and the bars.
Be sure to use two persons to lift and move
it.
When transporting the table saw by
vehicle, secure
it
with
a
rope or other sub-
stantial means.
ASSEMBLY
The table saw
is
shipped from the factory with the ruler guides, miter gauge, saw blade,
rip fence, blade guard and table insert not installed. Assemble
as
follows.
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before assembly.
Installing ruler guides
Sliding fable
Fixed
fable
Install the graduated ruler guide on the
front side of the fixed table and the non-
graduated
one
on the
rear
side.
Use
the hex
wrench to tighten the bolts.
7
To Next Page
Loading...
Need help?
General
