12 ENGLISH
ASSEMBLY
CAUTION: Always be sure that the tool is
before carrying out any work on the tool.
Installing or removing jig saw blade
CAUTION: Always clean out all chips or for-
eign matter adhering to the jig saw blade and/or
blade holder.
CAUTION: Do not touch the jig saw blade or
the workpiece immediately after operation. They
CAUTION: Always secure the jig saw blade
CAUTION: Use only B type jig saw blades.
CAUTION: When you remove the jig saw
top of the jig saw blade or the tips of workpiece.
Fig.7: 1.2. Blade clamp lever
(released position) 3. Blade clamp lever
Fig.8: 1.2.
3. Roller
CAUTION: If the blade clamp lever does not
not installed completely. Do not press the blade
damage the tool.
Fig.9: 1.2. Blade clamp lever
3.
NOTE:
the cutting action changing lever to the position "III"
and slightly switch on the tool several times.
NOTE:
Hex wrench storage
When not in use, store the hex wrench as shown in the
Fig.10: 1. Hex wrench
OPERATION
CAUTION:
the workpiece.
CAUTION: Advance the tool very slowly when
cutting curves or scrolling.
gently move the tool forward along the previously
marked cutting line.
Fig.11: 1. Cutting line 2. Base
Bevel cutting
CAUTION: Always be sure that the tool is
before tilting the base.
Fig.12
Fig.13: 1. Hex wrench 2. Bolt 3. Base
Fig.14: 1.2. Graduation
Fig.15: 1. Hex wrench 2. Bolt 3. Base
Cutouts
Boring a starting hole
pre-drill a starting hole 12 mm or more in diameter.
Fig.16
To Next Page
Loading...
Need help?
General
