Manitowoc Flav’R-Pic FRP-250, Flav’R-Pic FRP-250SCI User Manual

Maintenance Section 4
4-4
Part Number 020003315 1/11
Front Serviceable Motor
a. With agitator arm in any position remove hitch
clip pin from the mushroom bushing on the rear
of the ice bin.
b. Push the agitator bar toward the bushing to
remove it from the paddle wheel hub.
NOTE: If a top mount ice machine is installed, sliding the ice
machine to one side will make bin component removal easier.
If the ice machine is hard plumbed it will need to be
disconnected.
Front Serviceable
8. Remove paddle wheel, bin liner and paddle wheel area.
9. Move the front of the agitator to one side and slide
the agitator forward until the rear of the agitator shaft
is clear of the bushing.
10. Remove the agitator from the bin area.
11. Slide the paddle wheel from its shaft.
12. Loosen the four knurled fasteners that hold the bin
liner in place.
13. Remove the bin liner.
14. Remove the paddle wheel area from the bin.
15. Discard the remaining ice in the bin.
FRP-250 (NON-CRUSHER) DISASSEMBLE THE
ROCKING CHUTE
1. Loosen the two knurled fasteners that hold the
merchandiser in place.
2. Remove the merchandiser.
3. Remove outer bracket.
4. Remove door lock.
5. Remove door.
6. Remove ice chute.
Ice Chute Removal
Hitch Clip Pin
Agitator Bar
Paddle Wheel
Mushroom
Bushing
2
1
4
5
6

Manitowoc Flav’R-Pic FRP-250, Flav’R-Pic FRP-250SCI Specifications

General

Brand	Manitowoc
Model	Flav’R-Pic FRP-250, Flav’R-Pic FRP-250SCI
Category	Beverage Dispenser
Language	English