104 Part Number Preliminary 6/11
EXPORTING DATA TO A FLASH DRIVE
Data can be copied from the control board memory to
a flash drive and used to transfer setup and/or cycle
data to a replacement control board or to transfer
setup information to multiple ice machines. Data may
also be requested by service department personnel for
analysis or as an aid to troubleshooting. The data files
are small and can be attached to an email.
1. Ensure that the ice machine’s power is on.
2. Press the Menu button.
3. Press the Down arrow until Service is highlighted.
4. Press the Checkmark. The Service menu will be
displayed.
5. Press the Down arrow until USB Setup is
highlighted.
6. Press the Checkmark. USB Stick will appear
highlighted.
7. Press the Checkmark again. A submenu with
Export ALL and Export Setup appears.
8. Highlight Export ALL or Export Setup, depending
on your requirements, and press the Checkmark.
A display of instructions will appear.
9. Follow these on-screen instructions to:
A. Insert Drive (Insert the flash drive into the
USB port on the ice machine’s control board.)
B. Press Check (Press the Checkmark.)
C. Wait For Comp (Wait approximately 5 to 10
minutes for the download to complete.
D. Export Complete will appear on the display.
The flash drive must be formatted before using,
All files and software on the flash drive are
removed during the formatting process.
USB Setup USB Stick Export All
To Next Page
Loading...
Need help?
General