12
Installation and Service Manual
INSTALLATION
GENERAL INSTRUCTIONS FOR REMOVAL OF GEAR MOTOR
These instructions are provided as a guide for the removal of the gear motor. Depending on the model
number of your dispenser, these instructions may vary slightly.
1. Disconnect power from the electric receptacle.
2. Remove all ice from the ice storage bin of the dispenser.
3. Remove the paddle wheel pin from the paddle wheel /
agitator assembly inside the dispenser bin.
4. Remove the agitator assembly from the dispenser bin
by pushing the agitator to the back of the bin. Angle
the front of the agitator to the side. Pull the agitator
forward then out of the dispenser.
5. Remove the paddle wheel from the dispenser by pull-
ing the hub of the paddle wheel to the back of the bin
and off the gear motor shaft.
6. Remove the splash panel from the dispenser and ex-
pose the gear motor.
7. Disconnect the electric connector from the gear motor
wire leads.
8. Remove the pin in front of the gear motor.
9. You should be able to remove the gear motor from the
dispenser.
10. To install a replacement gear motor, reverse this pro-
cedure.
Ice
Paddle wheel
Rocking chute
ice dispense chute
Drain pan
Gear motor
Water line
Beverage valve
(option)
Removable front
merchandiser panel
Ice bin
Agitator
To Next Page
Loading...
Need help?
General
