Manitowoc MII 150 User Manual

21
Installation and Service Manual
USER MAINTENANCE
PREVENTATIVE MAINTENANCE
1. Conduct daily maintenance of the machine.
2. Perform monthly maintenance of the machine.
3. Perform periodic maintenance and sanitizing of bev-
erage system.
4. Do not overfill the dispenser bin with ice.
5. Do not allow the dispenser to sit for prolonged peri-
ods of non use with ice in the bin.
6. Most ice dispenser service problems are caused by
low usage of the ice dispenser.
7. Do not allow ice to remain in the bin more than a day
in order to prevent ice from freezing together and/or
stagnant ice.
Possible excess ice storage reasons:
• Storage capacity exceeds daily requirements.
• Low demand during the off season.
• Dispenser oversized with future growth in mind.
Lower ice storage to meet one day’s needs. If you manu-
ally fill ice, fill only with the appropriate amount of ice. Fill
the dispenser with fresh ice each morning. Do not fill the
dispenser at night just before shut down. Ice cubes can
freeze together if not dispensed.
Contact MBE at 1-800-367-4233 for more information
about our ProActive Maintenance Program.
Preventative maintenance is a vital part of keeping your MII dispenser in top condition. Following the guidelines
below will assist you in continued trouble free operation of your unit.
P
P
U
U
S
S
H
H
F
F
O
O
R
R
I
I
C
C
E
E
D
D
A
A
N
N
G
G
E
E
R
R
C
D
E
F
G
A
B
HOW TO DISASSEMBLE FOR CLEANING OR MAINTENANCE
NOTE: Sanitize the ice dispenser at Initial Start-UP in
addition to monthly sanitizing. You will need screwdriver
in order to disassemble.
Disassemble parts in the following order:
A. Merchandiser
B. Ice chute
C. Paddle wheel pin
D. Agitator
E. Paddle wheel
F. Bin liner
G. Paddle wheel Area
Accessing a Dispenser Bin Top Mounted with a Mani-
towoc Cuber:
1. Remove the front panel of the ice machine.
2. Remove the ice deflection baffle. This will give you
access to the dispenser bin.
Accessing a Dispenser Bin that is Top Mounted with
a Manitowoc Cuber and Large Extended Merchan-
diser in front of the Cuber:
1. Access to the bin is possible through the strip lids
on the side of the Dispenser.
Disassembling the Dispenser Parts for Bin Cleaning:
1. Remove the front panel of the Manitowoc ice maker.
2. If the Manitowoc ice maker is operating, wait for the
sheet of ice to fall into the dispenser bin.
When the ice sheet falls into the dispenser bin, immedi-
ately place toggle switch of the ice machine to the “OFF”
position.
If the Manitowoc ice maker is NOT operating, place the
toggle switch of the ice machine to the “OFF” position.
3. On MD models without a top mounted cuber, remove
the plastic lit from the top of the dispenser.
4. Remove all ice from the dispenser.
5. Disconnect electrical power to the dispenser.
6. On the MD-302 dispenser only, remove the strip lids
off the top left and top right of the dispenser bin.
7. For the MD-302 dispenser only, there is a left bin
and a right bin. Clean and sanitize one bin, then
follow the same procedures on the second bin.

Manitowoc MII 150 Specifications

General

Brand	Manitowoc
Model	MII 150
Category	Ice Maker
Language	English