20
Installation and Service Manual
NOTE: This cleaning schedule is a recommendation. Sched-
uled cleaning must be in compliance with local health codes.
DAILY CLEANING
• Drain pan
• Grid
• Splash panel
You will need: Warm, clean water to wash and rinse
with, mild non-abrasive soap and a clean cloth.
1. Lift the grid and remove it from the drain pan.
2. Using mild soap, warm water and a clean cloth,
wipe the drain pan and splash panel. Then, rinse
with clean, warm water. Allow plenty of warm (not
hot) water to run down the drain of the drain pan,
to remove residue that can clog the drain opening.
WARNING! Do not pour hot coffee into the drain pan. Pouring
hot coffee down the drain pan can eventually crack the drain
pan, especially if the drain pan is cold or still contains ice.
3. Wash the grid, then rinse with clean water. Place the
grid back in the drain pan.
4. Wash all exterior surfaces of the unit with warm wa-
ter and a clean cloth. Wipe again with a clean, dry
cloth.
5. Rinse nozzle and diffuser with warm, clean water.
CLEANING AND SANITIZING THE DISPENSER
1. Mix a solution of mild detergent to clean the dispenser
bin and components.
2. Using the mild detergent solution, a soft bristle brush
or clean cloth, clean the following dispenser parts:
• Entire bin
• Paddle wheel
• Paddle wheel area
• Agitator
• Paddle wheel pin
• Ice Chute
• Rear bushing
• Motor shaft
• Strip lids on model MII-302 & 402
3. Rinse all the parts in clean, running water.
4. Mix a sanitizing solution of 1/4 ounce of liquid, un-
scented laundry bleach (5.25% Cl Na O concentra-
tion) for each gallon of water. Or mix a solution of
water and sodium hypochlorite mixed to yield 100
PPM of available chlorine.
Or mix a solution of any approved sanitizer, following
the directions for mixing and applying the sanitizer.
5. Using the sanitizing solution, a soft bristle brush or
clean cloth, sanitize the dispenser parts listed in step
2 above.
RE-ASSEMBLING THE DISPENSER PARTS
1. Re-assemble parts in the following order:
• Paddle wheel area
• Bin liner
• Paddle wheel
• Agitator
• Paddle wheel pin
• Ice chute
• Merchandiser
2. Hand tighten all knurled fasteners.
3. Pour in fresh, sanitary ice and replace the plastic lid
on the top of the dispenser.
4. Plug in the unit’s electrical cord.
5. Check for proper ice dispensing.
USER MAINTENANCE
SANITIZING AND CLEANING
To Next Page
Loading...
Need help?
General
