16 Part Number: 040006977 Rev. 01 03/19
Operation Section 3
Operational Checks
GENERAL
Your ice machine was factory-operated and adjusted before
shipment. Normally, a newly installed ice machine does not
require any adjustment.
To ensure proper operation, always follow these Operational
Checks when starting the ice machine:
• for the first time
• after a prolonged out of service period
• after cleaning and sanitizing
Routine adjustments and maintenance procedures outlined
in this manual are not covered by the warranty.
Important
It is recommended that adjustments made to this ice
machine be made by a qualified technician. Improper
adjustment, may seriously affect the life of this ice
machine.
ICE CUBE THICKNESS CHECK
The ice cube thickness is factory-set to maintain the ice cube
thickness at the proper size and weight.
1. Allow the ice machine to operate for three complete
cycles. The cubes should have a small dimple in the
center.
2. Cycle times vary, according to surrounding air and water
inlet temperatures.
3. If cubes are not full (large dimple), raise the “dip
switch” level to increase cube size. Allow ice machine to
complete three cycles, then check cube.
4. If cubes are too full, ( no dimple), lower the “dip switch”
level to decrease cube size.Allow ice machine to operate
three complete cycles.
5. The “dip switch” can be adjusted to five levels: -2/-
1/0/+1/+2, and ensure that only one level switch is
pressed.
CUBE SHAPE
The standard cube has an average weight of 19 grams, Notice
the normal dimple in the center of the cube.
Decrease
Cube Size
Factory
Default
Setting
Dip Switch
Increase
Cube Size
34
Dimple
Standard Cube 19g
To Next Page
Loading...
Need help?
General
