Part Number: 040006977 Rev. 01 03/19 19
Section 4 Maintenance
Step 5 While components are soaking; use nylon brush to
scrub inside of ice bin. Scrub inside of door, door track, bin,
sump trough, and evaporator moldings. With clean water,
rinse all of these areas thoroughly.
Step 6 Replace sump overflow tube and pour remaining 2
liters of mixture into the water sump. Replace all parts.
Step 7 To start a standard cleaning cycle, press the toggle
switch to WASH position and hold for 5 seconds.
Step 8 Wait until the cleaning cycle is complete
(approximately 13.5 minutes). Remove water curtain, ice
chute and over flow tube from the water sump. Allow all
water to drain from the sump. Replace drain plug.Press the
toggle switch to WASH position and hold for 5 seconds to
start a rinsing cycle.
Step 9 Wait until the rinsing cycle is complete
(approximately 12 minutes). Remove water curtain, ice
chute, water sump over flow tube. Drain water from sump
and replace tube.
Step 10 Mix 60 ml of sanitizer with 12 l of water in a plastic
or stainless steel container.
Sanitizer Water
60 ml (2 oz) 12 L (3 gal)
Step 11 Remove Water Curtain and Ice Chute as described
in Section 3, Component Identification & Removal.
Step 12 Take all components to sink and with 10 liters
Sanitizer/Water mixture sanitize all components with a soft
nylon brush or cloth. Do not rinse components.
Step 13 Use brush or cloth to sanitize the inside of ice bin.
Scrub inside of door, door track, bin, water sump, water
distribution assembly and evaporator moldings. Do not rinse.
Step 14 Replace sump drain over flow tube, and transfer
remaining 2 liters of solution to the sump trough. Replace all
components.
Step 15 To start a standard sanitizing cycle, press the toggle
switch to WASH position and hold for 5 seconds.
Step 16 Wait until the cleaning cycle is complete
(approximately 13.5 minutes). Remove water curtain and ice
chute Remove over flow tube from water sump and allow
all water to drain from sump. Replace drain plug. Press the
toggle switch to WASH position and hold for 5 seconds to
start a rinsing cycle.
Step 17 Wait until the rinsing cycle is complete
(approximately 12 minutes). Remove water curtain, ice
chute, water sump over flow tube. Drain water from sump
and replace tube.
Step 18 Replace all parts.
Step 19 Place toggle switch to ON position,ice machine will
go into ice making cycle.
NOTE: To terminate a standard cleaning cycle, press the
toggle switch to WASH position and hold more than 30
seconds
,
Caution
If the cleaner /sanitizer solution has been poured into the
water trough, then the standard cleaning cycle must be
completed. Don’t terminate the cleaning cycle, or the ice
machine will not purges the remaining cleaner /sanitizer
solution from the water trough.
Exterior Cleaning
Clean the area around the ice machine as often as necessary
to maintain cleanliness and efficient operation.
Sponge any dust and dirt off the outside of the ice machine
with mild soap and water. Wipe dry with a clean, soft cloth.
A commercial grade stainless steel cleaner and polish may be
used.
To Next Page
Loading...
Need help?
General
